Step 3, Day 1 - Provisioning for our week aboard our classroom, "About Time"

Saturday night, after being introduced to the boat and each other, we sat down in the Galley and came up with a meal plan and then a shopping list, by grocery store department, for the week to come. We walked about a half mile to a grocery store, broke up the list and went shopping! We also walked across the parking lot to the liquor store for some other essentials ;-)

With our three carts worth of bagged groceries, we hailed an Uber XL for a ride back to "About Time". We stowed all of our groceries in the galley, which honestly all seemed to disappear in to so many nooks and crannies. While the boat lacked in storage in the cabins, there is a surprising amount of storage in the galley/saloon. We honestly probably could have provisioned for 150 meals instead of the 75 we provisioned for.

For dinner, we walked about 10 minutes to go to a burger place called BRGR STOP. Glutenous menu of piled high burgers and milkshakes, which were really good. Unfortunately, the place decided to have a DJ with blaring music starting at about 9pm, which effectively ended our conversation and completely ruined our otherwise good experience. Why must places do things like that?!

Back to the boat for an early morning trip down the ICW (Intra-Coastal Waterway) to Port Everglades and the open ocean.

- Mike

Comments

Victron Isolation Transformer - How to lower the output voltage

Re-configuring a Victron Energy isolation transformer This is a companion article to a YouTube video covering the same topic. What are they and why do I need one? Victron Energy isolation transformers are often used on boats that connect to shore power in order to provide a means of providing isolation between the shore power and the AC power that exists on the boat. The transformer sits in between those two worlds and isolates that two power supplies through magnetic flux and an air-gap. The reason this is needed on a marine vessel is because without it, small leakage currents can flow between the earth ground for shore power and the "earth ground" connection on the boat, which is usually connected to water through a propeller shaft, out-drive, sail-drive or sacrificial zincs. That creates a loop and that small leakage current greatly accelerates any galvanic corrosion that naturally happens. Current flows through the water because of the salt content, or even in fresh-wat...

Raising the dinghy, easier!

The Davit System The Vision 444 comes with a Carbon Fiber Davit system that is used to hoist a dinghy. As time has gone on, some of the exact specifics of the davit system have evolved and changed slightly, but for our boat (Hull #11) and the ones near to it, this is how it operates. Two Main Steps First, after attaching the dinghy to a forward and aft attachment line, the davit arms are raised; pivoting on axles which mount the davit to the transom of the boat. This step is accomplished by attaching a line which runs through several blocks to the starboard, aft power winch. Pressing "2" (low speed) on the winch power buttons and raising the davit into its full upright position, where it can be lashed to the boat with Dyneema loops. Second, is to raise the dinghy to be close under the horizontal beams of the davit arms. The dinghy attachment lines, that are attached to the dinghy's bridle, run up through a fixed block at the end of the davit arms and then t...

Vision 444 - How to (hopefully never have to) use a Storm Sail

How to use the Storm Sail on a Vision 444 My fellow Visionary Pierre on Umbono reached out recently wanting to review the steps for deploying the Storm Sail, since he was forecasted to be in less-than ideal sailing conditions in the next day. What better opportunity to write a blog article! This is going out quickly to support Pierre, but I will come back and add pictures and maybe link a video later. Preparation Keep the Storm Sail and everything you need for it somewhere where it is easy to get. We keep ours in the large lazarette under the Cockpit table seating. If you think you might need the Storm Sail, you probably should have the jacklines put out too. The system we use to deploy the Storm Sail reduces the time we need to be forward, but wearing a life vest with harness and being clipped into the lazy jacks is the way to go here. Our Storm sail is in it's own bag with the following: A port sheet attached to the clew with a bowline A starboard sheet attached to the cle...

On A New Tack

Search This Blog